Electric pre-plasticizing solution

Electric pre-plasticizing solution

The large model injection molding electric pre-plasticizing retrofitting brings high production capacity, energy saving, and improves the competitiveness of the enterprise. Moreover, the project cost is low and the investment return is fast. Application of electric pre-molding:

Electric pre-plasticizing retrofitting will be widely used on large model injection molding

Advantages of electric pre-molding

• Energy saving: no hydraulic energy loss, at least 15% - 40% energy saving. Plastic charging accounts for 50% - 60% of the total energy consumption.

• Efficiency improvement: direct drive, and in the long time charging action, the machine can do parallel actions

• High accuracy of material charging: Material charging stable and low speed fluctuation improve charging accuracy

• Clean and simple: no need oil circuit and easy installation

• The cost is relatively low

• Low noise

SEBOS promotes standardization of electric pre-plasticizing retrofitting in the industry

Integrated power cabinet High torque motor with reduction gearbox

• SEBOS provides complete scheme selection and accurate installation scheme mode

• SEBOS provides integrated power cabinet, high torque motor with reduction gearbox, independent oil cooling system of servo motor and any other process or spare parts that needed

SEBOS electric pre-plasticizing project advantage

• Design Standard Specification: Servo model and installation is standardization, and all accessories are top brand products

• Timely delivery: servo system is standardization, keep in stock and ready to delivery

• High protection design: IP54 protection design meeting international requirements

• EMC high-dimensional design meets EMC C3 standards

• Efficient heat dissipation design: high reliability and environmental adaptability

• Easy installation: the signal terminal is pluggable, the power cable is easy to install, and can support the side bottom incoming line

Real case